It looks ugly and will make the splice much larger once it’s covered with tape.Īfter the splice has cooled, trim any loose wires that could poke through the tape or shrink wrap. While you want the solder to cover most of the splice, try to avoid leaving big globs of solder on the joint. Touch the iron and solder to a few points on the splice to make sure it is uniformly spread throughout the wire strands. Capillary action plays an important role in distributing the solder throughout the splice. Holding the iron below the wires allows the heat to travel upwards while gravity pulls the molten solder down. Instead, allow the iron to heat the wire to the point that it melts the solder. When melting the solder to the wires, try not to touch the iron with the solder. This helps to spread out the heat when the tip touches the wires. Turn On: How To Install Switched Accessory Power To Your Motorcycleīefore touching the soldering tip to the wires, tin the tip by melting a small amount of solder on it. Anyone, even someone whose hands shake as much as mine do, can learn to solder with a minimum expenditure of blood and treasure. The source of the splicing fear usually is ignorance about soldering, which apparently many feel should only be done at midnight, during the full moon by a practitioner of the dark arts. Never fear, it is perfectly acceptable to splice wires if done correctly. However, soldering is also a great source of distress amongst novices. Soldering uses a hot iron to heat the wires to a temperature that will melt the solder, which when it cools takes care of the sturdy physical connection and the electrical conductivity. Mechanical connectors which physically clamp the wires together or to a common conductor are the easiest, but they take up more room and particular kinds are prone to failure. This can be done a couple of different ways. Wire splicing is the process of physically connecting two or more wires to make a mechanically strong, electrically sound path. While cutting your motorcycle’s wiring harness is not to be taken lightly and should only be attempted when you are certain as to which wires should be cut – by, say, obtaining the factory service manual – the process isn’t really that scary. Upon a little digging, the bugaboo is usually fear of splicing wires into the bike’s harness. Time and again, I’ve had people tell me that they are afraid to modify their bike’s wiring harness to install a new accessory.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |